manofwarsaw
12-04-2006, 07:13 PM
I have the White Nexus and Cen-Tech multi meter. When I try to read the ohms form the 2 solder pads next to the power connector I get nothing. If I touch 1 solder pad with both probes I will get a reading. I can also get a reading on the bottom side of the Nexus by touching 2 of the trim pots post. Which is the correct way of reading the ohms ? I want to solder wires to either the solder pads or the post on the bottom side to make permanent connections on the outside of the case to read the ohms. Thank You