PDA

View Full Version : Bev 5800

playisfun60
12-22-2006, 07:04 PM
Have done the R44 Vidmod When I am programming the SA70 on both flash 1 & 2 gets an error at the end when programming, and when I erase both flashes three times and go and check the IRD and BOXKEYS are still there Need help PLZ
playisfun60
12-23-2006, 12:29 AM
Need Help PLZ!!!
playisfun60
12-26-2006, 08:38 AM
Help
Dave411
12-27-2006, 03:46 AM
Kinda difficult to know, but my guess would be a problem with the vidmod. Since you can jtag, figure the OJ1 is OK. It would seem that the 9 volts are not getting to the U7 since you cant write the the new flash. I believe I fired up the jtag on the standard 3 volts, erase the TSOPs, then applied the 9 volts to write to U7. Since I dont know what kind of switch you have between the points, just remember you only want to apply the 9 volts to the one side going to U7. Good luck.