310-13 dual dead...help

[cowboyrex]

I killed my 310-13 dual tsop ird due to eraseing both flashes back to back. I tried Wall to bring back to life with no luck. Will someone help me revive this ird. Thanks in advance

[SURFGUY]

Keep trying with WALL, it will work when it gets good and ready.
I have reveived several IRD's with this progy! I hate this progy, because it is stubborn, but can be made to work if you keep at it. Also try a search of the forum for the WALL information, and you will eventually get the hang of this progy.

Also, use this and J-keys progy at the same time and you will eventually get it to work!

Good luck,

Surfguy;)

[skinerd]

There is no reason jkeys will not reveive a -013, single or dual.
Just ground the R79 point and you'll get it.

Wall2 has saved a few -010's for me but never a -013.

[cowboyrex]

Skinnerd, explain the R79 gound point. This ird has no vidmod. I never had to do one on this ird. Will I have to do one now or just gound R79 point.

[SURFGUY]

I had my best luck when I started flashing the IRD with WALL, giving it the wrong filesize, and when it completed(with or without errors) I switched over to J-Keys. Kept swapping progys until J-keys finally recognzed the IRD, and continued with completing the flash!

Otherwise the WALL program "STINKS" !!! -- But it will revive the IRD when the J-Keys progy won't. The WALL progy always has awakened my IRD's that were dead. Enough for the J-Keys progy to take over and do a perfect flash!

LOL,
Surfguy:cool:

[skinerd]

Grounding R79 point puts the receiver in link mode, makes working with flashes easier.

I agree the -013 is not a top of the line receiver, but I have gotten many, many of them working. I have lost a few too, but mainly what someone else sent me when they screwed it up.

[Little Kenobe]

ive been thru this a number of times .. use the wall and erase flash several times .. it will prolly complete without error .. choose number two flash first .. after erasing flash then load your flash 2 and write it .. when it stops and gives error just keep writing same flash over and over .. do not erase again just keep writing same flash .. when it takes about 1/4 of the flash or more and stops on error programing .. go to jkeys and write that same flash to it .. it will prolly work just fine .. then go back and do same thing with flash one .. write to all 200,000 sectors at ALL times .. hope this helps

LK

[skinerd]

You have to understand a little more about Wall2 than is posted here, you need to know the address of the flash etc.

Wall was specifically written for a 3100/301-010. I have never needed it for anything but those receivers.

[cowboyrex]

It's alive again!!!! I worked on this dang thing for hours and finalily got
it going again. I used wall 2.0, 2.2, and several jkeys and not sure which got it going. Jkeys 301-13b was the last program I was using to program flash back to the ird. I programed flash 1 first, erased flashed 2 5 times and then programed flash 2. All is well. I want to thank everyone here for your input.
You just dont know how close I came to throwing it in the trash. Later I may try to change this 301-13 dual ird into a pansat2500. That's what I was trying to do in the first place. Again thanks to everyone and have a MERRY
CHRISTMAS.