301-13 single vs dual

[kzz21]

Can someone tell me how to tell the difference. Thanks

[tommyoz]

Yes, look inside the IRD from the front. See the big Processor chip? it's located between the center and the back but more close to the center and a little to the right.

There are 2 chips on each side of that processor. Look at the one on the right. There should be another one next to it if it's a 2 chip. If it's a 1 chip then there would only be the one and a space for one.

[kzz21]

thanks one more time, I'll search for programing..

[kzz21]

Hit a little snag , went to jtag ,,,,, (I use to do 301-10s) It only has 16 pins not 20, can I still use it or if not wheres a good place to get one. THANKS AGAIN

[tommyoz]

If you used it for 301.010 then I don't see any reason you can't do 301.013. I have one I bought from Milli and it works great for both.