301-13 dual tsop to FTA problem

[dishfans]

I found a mod "dish_013_completo_110_119(2ChipU12).bin" with a eeprom file that is supposed to mod a 2 tsop 301.13 to fta.

I used a 301.13 2 chip box and applied the bin and eeprom using jkeys. I dont have a vid mod but I did get a good read and write using the ground switch.

The ird boot up and displays the new "mexican mafia" screen and all the menus seem to work. However I dont get any picture. Screen says scrambled...I am getting good signal and the guide also loads...also loaded keys manually and autoroll both but black screen

Help, what am i doing wrong?

[seaboard18]

I could be wrong but I thought I read that the fix would only work on the single tsop for a 301.

[foxx1600]

fta dont autoroll ull have to set up keys manuely is many discussions on how to enter pansat keys manualy

[jim7219]

it will work for dual tsop (watching as I type). There are 2 types of dual tsops one you need vid mod and the other you do not. If you got the mafia screen you do not.
You have done the flash ok what you need to do is to go into the parent control to provider setting and change it to 0101 and put the current keys in (no auto roll).

[dishfans]

Thanks for your input. I`m relieved that at least SOMEONE is watching tv on a dual tsop...Yes i did go to parental settings and selected nagravision 2 whick brought up the name dish network on the next screen..then i entered key 00 and key o1 (which was big pain since i had the dish remote and could only use pageup and pagedown for alphabets)...afterwards it still says scrambled...Darn it
BTW, will it take care of map 57 channels also???...i`m currently using atmega on a 2700 and its working great but some channels are blacked out due to MAP57.....i hope by converting 301 to pansat, it will be taken care off...you think?

[crazycat]

I desperately need a step by step for converting my dual tsop 310.13 to fta. I have been testing plastic for a couple years, but don't get along very well with my jtag. Any help would be appreciated.

[crazycat]

Everything I have seen seems to skip a step. Would a more knowledgable member please point me in the right direction? I read the long thread on another site, but most of the info seems to contradict itself. I have a simple jtag and my 301.13 does meets the cirteria not to requre the vidmod. I know these are rare, but that is just me... an oddball! Thanks for any help you can send my way.