mikn2 problems

[DeathAngle]

Hi i have a mikn2 i am having problems with this unit i cant get it to see card when i try to unlock i cant get it to read card in nagraedit 2.58 but it will read with iso in nagraedit 2.58 have checked script in winexplorer settings and all looks ok whatt else do i need to check when i try to flash it flashes with no problems Please help what do i need to do worked fine a few days ago Thanks for any help or info on this/DeathAngle:confused: :confused: :confused:

[Zim]

what flash are you using on the atmel?

[DeathAngle]

Flashing unit with ndrs for unlocking 109/10b

[DeathAngle]

Thanks for trying to help with this ..

[Zim]

using the same commport?...I am sure you know this but the card goes in with the contacts facing up....also what error do you get in winexplorer?

[DeathAngle]

card not present or inresponsive unable to continue is What im getting with winexplorer Thanks again for your help

[DeathAngle]

useing same comm port comm1 with chip up in mikn2

[Zim]

souds like a bad mik...not sure though.....does it have any dips or jumpers?...also on my mikIII for some reason I need to put a business card in with the 102 for it to make good contact could be the same prob with your..worth a shot .....

[DeathAngle]

will try hooking up another card slot to it ..Thanks again for the help

[DeathAngle]

still a no go ..Thanks for any help

[eevo66]

where r u setting ur pot? if its all the way turnedleft it wont work. if its turned all the way to right it will read but more than likely it wont unlock card, try to turn the pot all the way left so u know its turned as far as it can go thyen turn it to about the 11 oclock position, see what that does. thats unlocks for me in less than 5 seconds, but u may have to play with the settings a little (dont turn pot while its glitching) try that setting and post results. good luck

[DeathAngle]

I dont think it is is pot setting thing i think i shorted the unit out somehow is ther a way of checking it to make sure none of the chips is fryed.. like testing with omh meter ..i have another unlooper to fix this with if i have too .. Thanks for the replys on this..DeathAngle