Load Eeprom Problems

[ToUgHsPoT]

Can someone please help me with this problem. My Enigma "TEST CARD" is okay, then the "ROM" load successfully; but when I attempt to load the eeprom I keep getting "USB->BAD CPU-? RPM->? EEPROM->?"

I changed PC's and also tried diffferent versions and I'm still getting the same error. I have 2 brand new enigmas and they're both giving me the same errors?? Any ideas to slove this problem would really be appreciated.

Thanks

[Eldune]

Check milis new sticky and try to keep the cable short.

[Ohms]

I was having the exact same issue. I found that 3.4 would load the eeprom perfectly every time, while 3.5 would fail 90% of the time. This did not vary with the various usb cables I tried.

[desm]

3.5 program does not work proply -try 3.4 and laod keys as needed

[coolgrin]

I read that there are 2 kinds of cables that will fit the card a 4 pin and a 5 pin.The 5 pin is what is needed.Might try slight wiggles of connection on card.But I am sure it has to be either cable or drivers I do not think it is your card but it could be.they sell them everywhere ebay as low as 2.99 plus small shipping fee. Including the propper cable with card would be a heck of a nice bonus in future enigmacard sales.Just a suggestion but would solve a lot of problems down the road.I have seen many posts of this same issue and 7 outa 10 is cable 2 is drivers and 1 actual dud cards.

[ToUgHsPoT]

Check milis new sticky and try to keep the cable short.

Yep, you are correct my most informed fa-rend...............Cable was too long. I had a USB extension cable and when I removed it, the EEPROM load successfully.

Thanks to all for their input.