CROW --need some 2700 info

[mikepr]

If I read that column right...the pansat 2500 ( i have a clone) is close to running out of memory .Its still being updated but on its last legs..You mentioned something about converting your clone to 2700..In your opion do you think(when the 2500 finally go down) will last a little longer???and will they keep being updated as well?

Thanks in advance

[Crow 492]

If I read that column right...the pansat 2500 ( i have a clone) is close to running out of memory .Its still being updated but on its last legs..You mentioned something about converting your clone to 2700..In your opion do you think(when the 2500 finally go down) will last a little longer???and will they keep being updated as well?

Thanks in advance


Yes the Real Pansat 2700A is still good to go with good support. You will half to load clone safe bin's ether Vortex Bin's or the other's not Black list bins.
The Pansat 2700A clones has great support I have one here running good on both providers with the HH motor.

[mikepr]

I was at the pantec site and they said you need a jtag to convert it..is that true
This is what i have
Multistar Pantec Ultra flash memory 2 M byte
SDRAM 8 Mbyte
cpu clock 81 MHZ
can I just load a file onto that as well.........and would you say in the long one itd be better to put on now?

[Crow 492]

I was at the pantec site and they said you need a jtag to convert it..is that true
This is what i have
Multistar Pantec Ultra flash memory 2 M byte
SDRAM 8 Mbyte
cpu clock 81 MHZ
can I just load a file onto that as well.........and would you say in the long one itd be better to put on now?



Yes only J tag to convert only
Then you use your same loader & cable to but Pansat 2700 clone safe bins from there.

[mikepr]

is their pins on my board (listed above) or would I need to put some on..(eg plug and play or do i need to tinker)

[Crow 492]

is their pins on my board (listed above) or would I need to put some on..(eg plug and play or do i need to tinker)


My clone had a j tag port on the bord open it up and if you see a black port with pins standing up with a notch out on one side that would be it and it will be very easy plug and play. Get a J tag cable at any FTA store they are about 20.00$ then you can do all your friends.

If its a pentac I am shure you have one I know the Pansat 3000 does not and needs to be soldered to the board.

[Phottoman]

Crow, without butting in, and in this same thought on the 2500, did you get the email I sent you?

Photto

[Crow 492]

Crow, without butting in, and in this same thought on the 2500, did you get the email I sent you?

Photto

Dont load it to a real Pansat 2500.

[Phottoman]

Crow, I sent you an email, about a week ago, did you get that? It has nothing to do with a 2500 nor a 2500a. Or PM me and tell me how we can communicate.

Thanks.

Photto