Event Locked Enter Password

[billmlater]

So with my updated firmware, freshly flashed eeprom, prescribed boxkeys, I'm
trying to figure out what to do with this 076 message

Thoughts....

[mopar611]

Reread your tsop..

In jkeys, virginize your eeprom and write it to your recevier..

That will reset your eeprom to virgin and your lock nag will
go away..

Mopar

[billmlater]

OK. And I apologize if this belongs over in the noob forum. Thinking I was following your instructions, in jkeys, I read and saved the tsop. Then I erased the whole flash, then I programmed the flash with what I had just saved. I really need a good clear thread on 'just to virginize and reset the eeprom.' When I open up eeprom programming I do not know what Im looking at.

[gcan]

OK. And I apologize if this belongs over in the noob forum. Thinking I was following your instructions, in jkeys, I read and saved the tsop. Then I erased the whole flash, then I programmed the flash with what I had just saved. I really need a good clear thread on 'just to virginize and reset the eeprom.' When I open up eeprom programming I do not know what Im looking at.

first thing's first, what model and build receiver are you using.........................gcan

[billmlater]

3700, Cbsd

[billmlater]

Moving on, I have gone through the paces in virginizing and saving an eeprom.
I have tried it with 2 different tsop's (first didn't work). 2nd didnt either. the 1st was from my very frist read before any changes. The 2nd was from the new tsop created from the enigma process. Still stuck on 076. Which is the correct tsop to virginize? Using flashedit 2_1__1-1[1].02.a

[fubr]

sometimes a virgin eprom will make the password ffff so you simply enter enter enter and enter then hit ok.
In other words scroll past the menu **** over to ok and then hit ok.
try that.

[billmlater]

Thanks. That method gives me ch 101, but an 05 not authorized error on everything else. Dont get me wrong...six days in my very first attempt at testing...I am thrilled with my progress, and I have the sense I am very close.

[billmlater]

Need a littlr more understanding on eprom, and again sorry if this is the wrong forum. 1. Should I be making the eeprom from the tsop I first took off the machine, or from the the tsop that was the result of the enigma provided edits?
2. the build config that appears in jkeys is one letter different from the build config on the sticker on the mb? Which should I use, this unit is a 3700, and sys info displays compatibility for the 2700-2800-3700. 3. When eeprom programming the default ird selection is 2800...which I assume...is taken from jkey reading of the tsop, is it? Or should I be selecting 3700?

Thank you.