vs extreme??

[eddy]

110 scans only 74 channels and 119 124channels
i have removed the switch and scaned inividual lnbs
can this have to do with the sat and tp info?
currently my info does not include bu however when i changed my info and scaned bu it worked great on b and then the dish 110 and 119 vertical tps would not scan
so i droped bu and went back to where i am now it appears that the vertical tps are scanning on dish but i am not getting very many channels


all lnb freq set at 11250
lnb type standard

can anyone help??? please i have been at this for a while and am ready to pitch this thing out the window

[Crow 492]

110 scans only 74 channels and 119 124channels
i have removed the switch and scaned inividual lnbs
can this have to do with the sat and tp info?
currently my info does not include bu however when i changed my info and scaned bu it worked great on b and then the dish 110 and 119 vertical tps would not scan
so i droped bu and went back to where i am now it appears that the vertical tps are scanning on dish but i am not getting very many channels


all lnb freq set at 11250
lnb type standard

can anyone help??? please i have been at this for a while and am ready to pitch this thing out the window


When you took the swithch off did you get all your channels?. Allso the other problem might be the way you are doing your scan. Make shure that you do a factory reset in the menu so all the channels are out of your box. Then take your switch out and go direct to the LNB. Now when you are in the antena setup part were your setting's are make shure that your switch is off and that is all proper.

Now this is where you might be doing some thing rong dont do your scan from there do a bline scan from that sat or a power scan. If you scan from the where you do all your setting it will use the TP from the box insted of scaning the new one's out. You might half to exit once from the settings page to be able to do the power scan or blind scan.

I dont have that unit but thats whats going on by the sounds of things.

I hope it works

[aj1]

or you can try ....factory default
load the factory file
load a good satinfo file
load the latest file
then do your antsetup
scan channels using f1 auto scan
do not blind channel it only doubles up ypur channels
this always works for me
if not try grounding your switch