VEENER
02-22-2007, 06:48 PM
Hi,
I would love to get some help on this !
I currently have 91 and 82, both dual lnbs so a total of 4 wires going into a switch box. All prefessionally installed.
I currently sub to 3 bev stbs. The box had one extra output so I directly hooked up my new VS ultra to it.
I loaded the latest bin and then went into installation and chose Nimic 1,3. Then I proceeded to do a blind scan.
It first scanned the horizontals and then the verticals. After about 15 mins, it was done. Hit save.
I Then noticed I had doubles, sometimes triples of the same channels. It showed more than 600 channels.
I then hit SAT on the remote and it showed Nimic 1,3, Echo package, BEV package and ALL.
I chose BEV package, then it asked me to choose a channel. I just picked one because both choices were the same channel.
The channel list did not change. I was expecting it to be in the same channel order as my other three receivers.
Why did I get repeating channels and why is the BEV package not working?
I would love to get some help on this !
I currently have 91 and 82, both dual lnbs so a total of 4 wires going into a switch box. All prefessionally installed.
I currently sub to 3 bev stbs. The box had one extra output so I directly hooked up my new VS ultra to it.
I loaded the latest bin and then went into installation and chose Nimic 1,3. Then I proceeded to do a blind scan.
It first scanned the horizontals and then the verticals. After about 15 mins, it was done. Hit save.
I Then noticed I had doubles, sometimes triples of the same channels. It showed more than 600 channels.
I then hit SAT on the remote and it showed Nimic 1,3, Echo package, BEV package and ALL.
I chose BEV package, then it asked me to choose a channel. I just picked one because both choices were the same channel.
The channel list did not change. I was expecting it to be in the same channel order as my other three receivers.
Why did I get repeating channels and why is the BEV package not working?