enigma not authorized

[steamboatmickey]

two weeks getting life back in my 301-10 and now this enigma not authorized use s/w 3.8,3.9 can someone help me with this problem .
btw.jkey mega pack work great on 301`s

thanks

well 13hrs laterstill the same .i have a 301-10 s/w at 391 free channel, and a header of what is on but it goes black ,card not authorized and than 019error

need some help please program the card with no error{enigma}


well 2 more hour later check a read on ird and box and ird number are right all read look good enigma 3.9 i will older s/w for card do wish there was a way to clean the card.

[ToUgHsPoT]

two weeks getting life back in my 301-10 and now this enigma not authorized use s/w 3.8,3.9 can someone help me with this problem .
btw.jkey mega pack work great on 301`s

thanks

well 13hrs laterstill the same .i have a 301-10 s/w at 391 free channel, and a header of what is on but it goes black ,card not authorized and than 019error

need some help please program the card with no error{enigma}


well 2 more hour later check a read on ird and box and ird number are right all read look good enigma 3.9 i will older s/w for card do wish there was a way to clean the card.

If guide is "red" then your tiers have expired or you have no tiers on your bin.

[steamboatmickey]

useing supplied bin and eeprom. i do see i can not rite the new keys to it .and it is not rolling just not sure what do .or write or edit them in nagrs5.2
check guide all fine there
down load s/w 3.9 three times and not same sites and it is f--ked does not roll just sit and card not authorized and 019 back and fouth guild is good, sat are good

last s/w was good up and run will post back . btw that jkeys maga pack for 301`s is a life saver

last s/w download was form rom_ _ x
take for some help toughspot

[coolgrin]

look for a file called key update 8.2.3 or satjunkieslive 1.0 they are both good programs for changing keys.Or you can use nagramaster.Some of the new key grabbers now are just wild with what you can do with them.In enigmaedit 3.9 as long as you space the keys out right and update them after you load eeprom works fine,but I still use programs mentioned above to change keys on bins

[steamboatmickey]

coolgrin thanks for the info will look for it

[robm661]

the only way i got my 301.010 to work was use 3.3b then i failed with 3.4/3.5/3.6/3.7/3.9/ so i was using 3.3b then i reloaded the eppron on 3.3b then went to 3.8 and programed it with new keys and has been good with minor freezing but the keys have not changed give it a shot what do u have to lose