CEMU hardware question [Archive]

View Full Version : CEMU hardware question

bud42

03-20-2007, 03:16 AM

I've been trying to get cemu to run forever....I'm beginning to think it's a cable problem or some hardware issue. I've tried using two different 2313/232 emu boards and several different serial cables and two different computers but I keep getting no CAM ID and all red guide or just a 019 error?.....Do I need something other than a serial cable? I'm lost!! Anything else I need to check?
I've also tried several different receivers and any bin I use makes no difference with getting no CAM ID? Something isn't getting through not sure where the problem is?

03-20-2007, 05:11 AM

Does the receiver info on your .bin match the info on your IRD's tsop?

Lion

04-03-2007, 06:53 AM

Does the receiver info on your .bin match the info on your IRD's tsop?

How do you check the .bin info. I

Lion

04-03-2007, 06:58 AM

How do you check the .bin info. I
Everything really stalled out during my post. I'll try again. How do you check the .bin info. I think that my problem the last two months is related to that. I can't seem to get cemu to communicate with avr. The posted info on dishbin and bev bin is confusing. If I could read the bin info, I could decide what to include in my boot disk. 2700 avr3 B3V non buffered cable no communication from com 1 to avr3!! Ird modded to public info.