Motor setup questions.

[callen]

I recently bought a motor for my dish setup. I'm interested in using it for bev, dish and direct. I can't seem to get it to lock onto any birds though. I live in the Kingston Ontario area so I set it to true south (magnetic -13) put my latitude @44* for elevation on the motor and set the dish elevation to 30. The best strength I've managed to get is no better than 20%, before I installed the motor I got 90% with nimq1/2. I’m using DVBdream/mytheatre through a twinhan 1020 on a bell dish and single lnb setup.

This is the motor I’m trying to use.
http://www.moteck.com/product.asp?idproduct=52

[Crow 492]

I recently bought a motor for my dish setup. I'm interested in using it for bev, dish and direct. I can't seem to get it to lock onto any birds though. I live in the Kingston Ontario area so I set it to true south (magnetic -13) put my latitude @44* for elevation on the motor and set the dish elevation to 30. The best strength I've managed to get is no better than 20%, before I installed the motor I got 90% with nimq1/2. I’m using DVBdream/mytheatre through a twinhan 1020 on a bell dish and single lnb setup.

This is the motor I’m trying to use.
http://www.moteck.com/product.asp?idproduct=52

I moved your post to the right place.

I dont think that the Twinhann PCI card can do it unless its for true free to air with the factory software.

Maby I am rong but your post should give you awnsers here.

Hope you get it going