Help? Wicked 6.2, 301-010

[cricket1]

Anyone venture to guess why I can't get Wicked 6.2 to work on my 301.010 p392 (dish).

I get the same result as if keys were wrong...Guide with channels black. I checked, double checked, and even copy and pasted keys into jeepers.
.
I use the 18.00 mhz atmega, chose no-rsa, and the 119/110 sat. then input keys (many times) still only black screen.

The only wicked file I can get to work is the Wicked3b. 2.4. Anyone else have this setup that is running?

[empulse]

make sure its the latest from the file forum (Wicked 3M 6.2) and also you don't have to enter the keys at this time. 6.2 rolls like a pimp.

Its always good to erase your Atmega, I erase 3x with standard and use the other erase as well 3x. then program.

Keys should roll in a few minutes. Leave em zero'd.

[alsouthster]

working good here with 6.1, but read reports from experienced peeps having same prob, couldn't get it to work with the 6.X series no matter what they tried....

[alsouthster]

One thing you could try—if you're sure you gave it enough time for the keys to roll—is use Junior Roba to restore card to original state.
That was what was advised when the 6.2 was first released, though it runs good for most people without having to do that

[robm661]

just go to http://www.dss-newbies.net/ atmega files and use the one 5/17 with buffalo wicked 3m ar and type in your locals in min max change eeprom to where u live erase three times write keys then full monty milli i'm for posting another site on your i 've been seeing himhaving problem for a couple days,i tried to up;oad it

[robm661]

just go to http://www.dss-newbies.net/ atmega files and use the one 5/17 with buffalo wicked 3m ar and type in your locals in min max change eeprom to where u live erase three times write keys then full monty milli i'm for posting another site on your i 've been seeing himhaving problem for a couple days,i tried to up;oad itdont forget to put the keys in firstkey0 C9 82 3A AE 0B 0F 24 59 BB CD 40 B5 0D EB 6C 43
Key 1: CB FB 84 C0 97 81 54 5E 41 7F 6A 72 B0 2D 0C BC Active

[cricket1]

working good here with 6.1, but read reports from experienced peeps having same prob, couldn't get it to work with the 6.X series no matter what they tried....


Tried Wicked 3m 6.2, left in stream for hour, tried with or without keys, tried erasing card 3 times.....All No Go!

Used Wicked 6.1 and rolled withing 2 min. Thanks for all your help!

[robm661]

are u hitting write after u erase fist then hit write keys then full monty use the wicked 3m from that site with auto roll with buf locals works for about everyone one i know,which jeepers are u using

[robm661]

are u hitting write after u erase fist then hit write keys then full monty use the wicked 3m from that site with auto roll with buf locals works for about everyone one i know,which jeepers are u usingi tried all those files they all work just i like wicked 3m 5/17 with buf locals so i can easily add my locals so either your have a corupted file,down load them all over in a new folder did u try that and put all keys in not just active line