jc411911
07-06-2007, 05:00 AM
After reading these forums from front to back i am still having a hard time programming my own 301.013 dual build config DACA with atmega . Let me briefly go over the steps i have followed and maybe one of you sesoned vets can guide me in the right direction. First i saved my tsops and eeprom. Then i found the modified tsops and downloaded them from here i believe these are the right ones to get ?xxtp://www.filenanny.com/files/44f7b9c9f14e0/TSOP%20MODIFIED.bmp
then using flashedit i modified them using the nor-rsa mod. I believe this should be right i am not sure about the IRD # i left this to what it was don't know if i was supposed to put in my IRD# ?
hxtp://www.filenanny.com/files/44f7b9c9f14e0/flashedit%202%20flashes.bmp
I believe i am only supposed to worry about flash two so i just save that one.then i went back to jkeys and loaded flash one from the original one not the modified no-rsa one then i loaded flash 2 with the modified no-rsa . I did not mess with the modified eeprom as i dont believe that has to be messed with. I hook up the ird and programmed atmega 128 (which i know is working cause i have i tried it on a friends box) when i load the card it says invalid card and thats it . i have tried differnt variations of flashes over the past two weeks jtagging about twenty times and nothing seems to work. Like i said i read all the guides and forums before posting help , so any help would be greatly greatly appreciated.
then using flashedit i modified them using the nor-rsa mod. I believe this should be right i am not sure about the IRD # i left this to what it was don't know if i was supposed to put in my IRD# ?
hxtp://www.filenanny.com/files/44f7b9c9f14e0/flashedit%202%20flashes.bmp
I believe i am only supposed to worry about flash two so i just save that one.then i went back to jkeys and loaded flash one from the original one not the modified no-rsa one then i loaded flash 2 with the modified no-rsa . I did not mess with the modified eeprom as i dont believe that has to be messed with. I hook up the ird and programmed atmega 128 (which i know is working cause i have i tried it on a friends box) when i load the card it says invalid card and thats it . i have tried differnt variations of flashes over the past two weeks jtagging about twenty times and nothing seems to work. Like i said i read all the guides and forums before posting help , so any help would be greatly greatly appreciated.