522/625 help

[haz2]

ok this thing will power up kinda locked up when downloading program guide would hold the power botton on the receiver or just unplug and wait for 30 seconds or so then plug back in. it will get video and audio for about 5min then the thing just freezes just a frozen picture no error message just locked up. remote will do nothing untill unplugged or power button held down. receiver will boot back up and get a/v for about 5min same thing froozen picture. i let it sit over nite in the morning still frozen. unplug will boot up and get video.system info says software virsion L417 using rom code blocker. puzzling when i look at original card image in n2edit 2.58 in data type under ird info it says software virsionL295?? any suggestions or will be greatly appreciated thank you:confused:

[skinerd]

Looking at the bin in N2Edit the firmware rev and receiver type are really meaningless.

Did you correctly apply the Romcode blocker?? Is is specific for the type of CAM you are using?
Example, a 522 uses am I-cam, if you use a regular plastic blocker and did not corrctly move the dataspce then you will never get it working.

[haz2]

when i looked at eeprom data was at a700 when i put rc blocker on is that the correct location?