DT08 Input Needed AIOutil

[Eldune]

Anyone else get this error in aioutil when you perform calculation??????
Support files mabe????

[Crazy1_79]

the 102 image you are using must have dt08 on it. for instance if it was for a sk receiver dt08 would be 00'd out in program. You need to get a dt08 on the card if you are usign legacy receiver or 010. or you must choose the "this card uses sK" depending on what AIO clone utility you are using. some have that some don't. only calculate Sk if you have SK receiver

[Eldune]

Im trying to follow your emu guide to get a 3900 up and running with private#
It was running fine with public. St19 I have 311 811 and 310.13 single private bins.
Please shove me in the right dirrection. Thanks!

[Crazy1_79]

Ok this is what i want you to do. I want you to open up your card images in gendt08 and save the key file. then i want you to goto bellexpress.vu and dowload the gendt08 base image. next. open that up in gendt08 and load the keyfile you saved from yo0ur open cards. You may have to add the OA datatype like i talk about in the how to for private keyfile howto in general discussions forum. the legacy how to has you add oa dataype. then save that card image and use that one to try to use in the AIO utility. your cards are missing the dt08 for some reason. if you goto that how too the link for the gendt08 base image is there

[OverEasy]

Eldune are you trying to do CEMU or ST19 ?

[Crazy1_79]

think he had st19 but is now going to cemu unless i totally misunderstood

[OverEasy]

Well if it's ST19 he would not need to use the AIO program just make a copy of the .bin and change the copy to a .cor . If it is CEMU and his is trying to make a blue clone patch from his 102.bin for his dish.bin he can disregard the error and the patch will work just fine if the keyset on the bin matches the info on the IRD. The AIO program I have gives me the same error I just click OK and it still performs the calculations.

[Eldune]

Im trying to go from public # and flash to private# and flash.
3900

Thanks!

[OverEasy]

Like I said above you don't need a AIO patch for ST19 if you have correctly match/married the 102.bin to the IRD . Then you just need to make a copy of the 102.bin then change the copy to a ST19.cor and drag & drop that on to your ST19 floppy.

[Eldune]

Ill try that when i get back in a few weeks. I think for now I will just unplug everything. Im sure things will change anyway!

[Crazy1_79]

I bet you maybe right eldune