errol674
09-09-2007, 06:31 PM
Hey all.... I don't know if there is a fix for this but here i go.... I was loading the blacklist 2500 to 2700 jtag.. After it was done the computer said finished but I still had my nightrider light on but it appeared to be stayinging in one place.... So me not fully reading the instructions where it said to be patient and wait about 2 mins., I shut off the receiver in the rear and turned it back on and now I have no power and none of the loaders and bins that I try to load works.... I have a jtag cable that I had bought to jtag a 3500 that went dead... When I opened the 2500 I don't see any pins to plug the cable to.... Did I just majorly screw up???? Should I toss this receiver now???