BEV 6000 Ird and GenDt08 - Can I?

[dickched]

Hey,

I'd like to use private info with st19 and BEV with a 6000 Ird. I combined the TSOPs and tried to load them into GenDT08 and it doesn't recognize the ird type. Is there a definition for the GenDt08 config for Bev 6000? Will GenDt08 work with a BEV 102 image? Any other tips would be appreciated...

TIA,

DH

[dickched]

Nevermind,

I found a Gendt08 CFG Howto in TheFileShop. Edited my cfg and now it loads the combined TSOP just fine...

DH

[ddwood70]

Hi,
I am trying to do the same thing as you, use Gendt08 with a 6000 and bev.
Had not luck so far trying to create my own 6000 .cfg file to use with Gendt08.
Any chance you could supply me with a working copy of your config.?
thx ddwood70

[dickched]

I came up with this by following the directions in the readme from Gendt08. Be sure to either remove or comment out any other config info for a different 6000.

Use at your own risk! (Works fine for me) ;-)

DH



;BEV 534!!!!
// 6000 12N
//
// firmware=829P
// combined flash file
[6000]
model = 6000
modelid = 12NN
modelpoint = 3DFFF4
softwarepoint = 3DFFF8
checksumstart = 200000
checksumend = 3DFFFC
checksumpoint = 3DFFFC
checkpoint = 3DFF90
bootstrappoint = 3FFFA0
bootcspoint = 3FFFA4
buildconfpoint = 3FFFA8
irdnumpoint = 3FFFC0
boxkeypoint = 3FFFC8
rsa1 = 2C2BF0
rsa2 = 2C2C30
sk = 3FFF40
dualtsop = 0

[dickched]

Be advised that if you use Gendt08-sk you need to work with a rev240 bin. After you finish generating your private info and start to view with that rev240 bin, it will be VERY unstable and desub every couple minutes until you update the bin to rev248. I have a patch to do this but it's not with me. I'll post it later.

DH

[dickched]

DO NOT APPLY THIS TO A CARD!!!!!! ONLY USE WITH ST19XL EMU!!!!

I found this on extremetesting.tv. It was posted by clamdigger there. I don't know who actually wrote it but it works. It will update a cor file to rev248 and stop you from having constant de-subbing every couple minutes.

DH

http://bellexpress.vu/forum/local_links.php?action=jump&id=760&catid=64

[ddwood70]

Hi,
Thanks for the 6000.cfg, it works , now I can a least read my 6000 tsop with Gendt08. I can move on now and try adding my own tsop info.
Thx ddwood70