Jtag reading after re-flash

[hiraganna]

I reflashed my 301-010 with my RC IRD and Bkeys info. The flash was good but when I look at the info in Jkeys I have some jibberish for my modelID and software says %. Is this is a normal thing that will get corrected in the stream. If not how do I put my Model ID and software version back correctly.

[mannybeef]

no, that is not normal and will not be corrected by stream.

that is a bad flashing of tsop. most likely.

give you some advice, it took me a while to get the hang of.

you should never get the feeling that it may be right it must be right or that luck was on your side.

it must be perfect, you will get it eventually.

it seems at times that there are a lot of factors keeping the jtagging experience from being easy.

but just be patient and be mindful of everything your doing.

good luck