bones
10-25-2007, 03:04 AM
I have a 6000 IRD that will run great for a few weeks, then all of a sudden it will have no signal. If I do a check switch it comes back with no switch detected. If I hook up a 3100 and do a check switch it comes back ok, then usually I can hook the 6000 back up and do check switch and it will be ok for a few more weeks. The last time it happened I hooked up the 3100 and it was fine but when I hooked up the 6000 it still couldn't find a switch. Does anyone have any ideas or do I have to jtag it again. Its been awhile so I've been trying to avoid it. BY the way I am running on atmega. Any suggestions would be greatful.