6000 with Atmega 128- error 019

[v8vega383]

Using Jeepers with Satjammin's latest file, public for B*V (7.5 file) & Atmega 128. I keep getting the SCNIC, error 019. I have an Atmega 128 with 18.000 mhz crystal. Tried programming the Atmega with the 16-6k, 18-6k and 18.432-6k mhz in Jeepers, but still no good??? When I go into the system info, it shows me all S000000000's. It also shows "DNASP 102 JAMMIN" in the "new card ready" section underneath the zero's.

Any idea what's wrong? Recv'r works great with ST19 public.

[darren43]

must buy 18.432 atmega to use on 6000

[v8vega383]

Can I buy an 18.432 crystal and solder it on in place of my 18 mhz one? If I can't get an 18.432, can I use a 20mhz crystal?

[MaxmMhz]

I swapped an 18000 with an 18432 on a ten pin, worked great.

[v8vega383]

I couldn't find a 18.432 mhz crystal, so I got a 20 mhz off the shelf. soldered it in place of the 18mhz and tried it in my 5100, works good. Went to my 6000 ird, programmed it to 20mhz - 6k in jeepers and it still gives me all zero's, error 019? any ideas?

[hobbyer]

I am having the same problem. It worked great up to a few days ago, and now all I get is error 019. I have tried many many setings,cards, ect...

[ge2]

You have to chose 18.432-6000 option in jeepers for 6000, or 20.000-6000 if it's there.

[hobbyer]

I finally ended up using the pheonix loader on my 128-18.432 and it worked when nothing else would. I don't get it, but I tried a lot of combinations with atmega 128 and 256 before this one worked.