bev 2700 with atmega

[m1tk0]

hello all,
everything was running good up to about 4 hours ago. not sure what happened but screen wont go past acquiring signal. have the keys changed?

was using Wicked 3m BV roll.pfg also have tried 2007-11-10-IPREVERSE-BV-NO-NAG-127.pfg same issue

[MaxmMhz]

Try unplugging the Ird for a minute or two, then plug it back in and turn it on.

[m1tk0]

did that, same issue

[ruciz]

tree fall in front of your dish? nothing should lock up at aquiring signal...

reboot IRD like mentioned, or haul card, wait until you get the sys info screen, then put it back in...
could also do a check switch as that could have went cooky on ya.

[m1tk0]

signal is good, just tried my other receiver with SUB so it cant be the signal

[HRCguru]

How long is it on the acquiring signal screen ? Sometimes it takes 2 or 3 minutes for it to proceed to 4...5/5. If it hangs there for longer than 4 minutes , I would reprogram card and reboot receiver by replugging.

[m1tk0]

thanks for all the help, but as it seems 1 of my fuse bits were wrong, fixed it and reprogrammed now up and running
weird