TheDuke
11-27-2007, 07:52 AM
Well after looping 2 cams right away, I went a bit moe catious, I started at 7.5 volts @ 400 ohms. I worked my all the way down to 150 ohms, pounding the card for 1 hour at a time, then dropping the ohms by 10's. when i got to 175 ohms, i did it in increments of 5 ohms.
Now I went back to 9 volts, and worked my way down to 150 ohms ( except I started at 220 ohms ) and started noticing a pile full of 07+FF, and stopped glitching right away. Went to reset programmer by pulling power and things were hot. Not burn my finger hot, but hot. Nothing near cam was hot though, probably just the voltage regulator r something.
I have down this now with pins 3 & 4 down., and tried pin 1, but that was just steady resets.
So, my question is. Has anyone popped a rev 247 using less then 150 ohms, or even a different hz clock other then the 18.+ non-inverted ?
The locker is a blue nexus
Right now I am trying different variables , like setting glitch vcc resolution to .0655 from .0625. and the VS1 to 26 from 42
Now I went back to 9 volts, and worked my way down to 150 ohms ( except I started at 220 ohms ) and started noticing a pile full of 07+FF, and stopped glitching right away. Went to reset programmer by pulling power and things were hot. Not burn my finger hot, but hot. Nothing near cam was hot though, probably just the voltage regulator r something.
I have down this now with pins 3 & 4 down., and tried pin 1, but that was just steady resets.
So, my question is. Has anyone popped a rev 247 using less then 150 ohms, or even a different hz clock other then the 18.+ non-inverted ?
The locker is a blue nexus
Right now I am trying different variables , like setting glitch vcc resolution to .0655 from .0625. and the VS1 to 26 from 42