625 Wont Take Any Blocker 103

[SEARCHY4]

been messing with 102's to long.decided to fix a 625.everything went smooth except when i right any blocker out there with nagra master i get bug write failed.pop in ird.refuses to boot up.write my original image back then it boots up fine.

any idea.tryed using n2edirtbut says dont support 103.dose naga master have probloms with 103?

just want to get this damn thing running.

[guarionex]

Try changing ext bn103 to bn102 on bin before reading , upon read add tiers, time zone so on then change back to bn103 before writing blocker try using N2edit 2.58

[skinerd]

n2edit 2.58 does support 103s.

you can add tiers with MR tierworks, but it will need to be renamed to bn102 first, BE SURE to rename it back to bn103 before writing a blocker to it or writing to a card.

[SEARCHY4]

thanks for the tier tip.
right now i just want to get a blocker on the card so i can test and make sure the receivers working right.

fn2edit works better thanks.

but for some reason as soon as i add a blocker from my 382 rev card
the rec bont boot to aquire screen.
if i write my 382 rev back to card the rec boots up and try'es to aqr sat signal.

so why when i add a blocker dose the reciver not want to boot?

[skinerd]

thanks for the tier tip.
right now i just want to get a blocker on the card so i can test and make sure the receivers working right.

fn2edit works better thanks.

but for some reason as soon as i add a blocker from my 382 rev card
the rec bont boot to aquire screen.
if i write my 382 rev back to card the rec boots up and try'es to aqr sat signal.

so why when i add a blocker dose the reciver not want to boot?

Open the bn103, after reneming it to bn102, in GenDT-08, see if the numbers are good, blocker may be overwriting something critical.

[SEARCHY4]

ok.the original image looks fine.after applying blocker the image is provider unknown. can i use a 102 card? can i just save my dt06 ect and transfer to a 102?

[SEARCHY4]

also i forgot to mention i am using poolshark i cam 38c for blocker. the only currant blocker i can find

[SEARCHY4]

i got it.i cris crosed a wire on mod. wired to pin 10 instead of pin 11
works perfect now.