Coolsat 5000 AUX Card with ST19?

[docbones]

Hello,

I have a ROM102 card with the AUX applied from a Coolsat 5000. Would I need to modify this card in any way to use it with ST19?

I did not save the original image from this card at the time because I was new and did not know how. Is there a way to replace the image and esentially un-aux the card?

Thank you
docbones

[ruciz]

N2Edit
read
save
Clean codespace
write

now you have a virgin card.

Open Perky's Aux 1.23 in N2Edit
write

Now you have an aux.

ST19 is smart, and if you just add your -pa flag, it will attempt to read the aux from specified COMPORT. if its correct it should detect and show up AUX: 1.23 or something similar, if not the program will crash. If its 1.22 its best to update to 1.23. Just clean codespace, write, then open aux image and write that.

[docbones]

Thanks for the response ruciz.

For N2Edit, to read and write to my card would I just need an ISO Programmer or something more?

What works best for ST19? A serial or USB ISO Programmer? It would make sense to use a serial model as I am unsure how the system will know about a USB model without an OS, but I do not know enough about ST19.

Thanks again,
docbones

[McLovin]

i could not find Perky's aux in the file section.

could someone please post a link to the file, tnx.

[hughnohoo]

hxxp://dsscentral.net/dsscentralfilearchive2007updated/index.php?act=download&id=899