any help

[jr_8]

I am trying to get the st19xl to work with the card I had it working with out so I think the cor and everything is good but here is my problem when I click on the st batch file it starts and the light on my loader flashes then the window closes any ideas as to why this is what my command line says
ST19XL.EXE -a -m -s -pe1 -pa2 I am useing a max mel 2 chip board flashed to 10c

[jarmster]

you need to still use auxshare only set the option to use with a card.
Also load the card with the required image. BUT i don't think st19 is coded to work with a card as far as the new ecms go......I think

[jr_8]

you need to still use auxshare only set the option to use with a card.
Also load the card with the required image. BUT i don't think st19 is coded to work with a card as far as the new ecms go......I think
thanks I will give it a try

[jayel]

you need to still use auxshare only set the option to use with a card.
Also load the card with the required image. BUT i don't think st19 is coded to work with a card as far as the new ecms go......I think
Don't know what you're trying to say there, but auxshare is not needed. A regular boot floppy with st19 will work, but you do need an aux card programmed with perky's aux 1.22 or 1.23.
Also Jr_8, if your dos box closes imediately after starting in windows, sometimes it's because you have a instance already running. Control-Alt-delete to see what is running and see, if it is running already, you'll have to close the first instance then start it again.

[joesnuffy]

I posted how I am doing emu in the files section just look for the file posted by joe snuffy. I took other folks work and designed it to be used by folks that were using the virtual port concept. I put directions into it also. If you can't understand post questions. I love the concept you will need a card that is auxed I put alll the files in there with directions. You can use auxshare if you like I thank it made it easier I was good at the virtual port method using auxshare so I desinged this for folks like me that are learing. I even put in there how to choose your ports I use port 1 and 4 and thats in the directions of course choose your ports.

Joei

[ruciz]

auxshare can be used, but isn't needed. its actually kind of pointless as 'share' does not do anything of the sort. Hopefully slasher can get a new win32 sharing version out soon!!

Just basic ST19 with your command line will work.
IRD on COMPORT1 and AUX on COMPORT2.
pull IRD card, start ST19, push card back in. when you see scrolling hit S to stop it (saves a bit on CPU usage.. like it uses a lot anyway :P) then enjoy!

[jr_8]

I posted how I am doing emu in the files section just look for the file posted by joe snuffy. I took other folks work and designed it to be used by folks that were using the virtual port concept. I put directions into it also. If you can't understand post questions. I love the concept you will need a card that is auxed I put alll the files in there with directions. You can use auxshare if you like I thank it made it easier I was good at the virtual port method using auxshare so I desinged this for folks like me that are learing. I even put in there how to choose your ports I use port 1 and 4 and thats in the directions of course choose your ports.

Joei
I just wanted to say thank you I used the dos version and am now up with all channels again thank you for the time you took to help me out :)