Rom 102 stream locked script

[lgryjack]

I was wanting to know which script to use on a rom 102 card that is dealer or sreamlocked to unlock it. On rom code it shows up at a 10a, but its original rev when it was unlocked was at rev 103 when cleaned and read in n2edit. Do I use the script for the 103 or for the 10a. This is also on a wafer or bga board that has a chip mounted on it.

Thanks for any help, this is my first go at this.:rolleyes: :rolleyes:

[jacktha1]

did you program it before, if so with what

[lgryjack]

It has been programmed with rom code only. Before that it was a clean and unlocked rom 102 rev103.

[jacktha1]

i know someone that had that happen to them, all they did was delete RC reinstalled it. Restarted PC and it worked like normal give that a shot.

[lgryjack]

I have tried that already jacktha1, loaded it even on another computer, and still the same result.

[Bandit5906]

I have had some experience with a BGA and RC and it turned out to be the contacts on the programmer and the BGA. The card was not locked at all. Clean contacts, re-install RC, Re-insert the card in the programmer, put business card on top of the BGA and insert into programmer and/or all of the above.

It happens to the BGA often and so far it has never been locked at all.

[lgryjack]

It took me long enough, but I was able to read and clean the card in rom code. I had tried everything under the sun and nothing was happening. Cleaned contacts, reloaded rom code, tried 3 different loaders all last night. I then tried again today on my most recent loader and it worked, go figure!!! The card is similar to that of a bga board and I restarted computer both nights. Any ideas why this would be so delicate for some unknown reason??

Thanks for all the help and advice greatly appreciated

[Bandit5906]

The card is similar to that of a bga board