Did I just loop my card?

[Jcar1]

I just bough a nexus unlocker to unlock a 102 rev 105 that I bought. I flashed it will newd13 and started nagramaster. I was gliching the card for around a minute and then stated that the card had no ATR. How did this happen and could it be fixed?

[Jcar1]

It's not doing anything it says no ATR in N2edit and nagramaster

[The Lizard King]

It's not doing anything it says no ATR in N2edit and nagramaster
Yep, it's pooched. Sorry, but that's testing.

TLK :cool:

[Jcar1]

That sucks, did I do something wrong?

[ge2]

That sucks, did I do something wrong?

What were your program settings, Ohms and dip switches?

[Jcar1]

Dips 2 and 5 on.

[accesshu]

I hope you have more that one to play with. Do some more reading and get your settings before ya tackle the next one good luck.

[Jcar1]

I wish I did have another one. I followed the direction on the how to pages here.

[accesshu]

The omhs need to be just right or RIP 102. I was lucky I popped 2 before I looped my first one.

[joesnuffy]

I always use (older t911 modded) with 4053 chips on that rev I don't loose any that way. It takes a little longer to get in them like 2-30 mins but you don't loose any. I can't remeber the ohms (around 30ohms I believe I could measure if you need to know) I use I have a switch on that loader on one side its for 101s on the other its for 102s at cards around that rev. I haven't done one in forever. I have a Mik3 I also modded with those chips it works well also just popps them slower. You might be better off to send your next card to someone that has popped a bunch it cheaper than buying cards. If you had a problem with a low rev you will darn sure have a problem with higher revs since they are even more difficult to get into.

Joe

[Jcar1]

I learned the hard way. The only research I did was the how to pages on this site and it didn't say anything about ohms or what to set it to and I don't even know what mine is at.