PDA

View Full Version : Tsop Update now Card Invalid

Greystone
12-17-2007, 12:56 AM
I have lost my manual, so I am lost. I just upgraded my 4900 to firmware 326 from 322, changed the firmware to No RSA Numbers, and wrote it back. Reread and it seems okay. Now when I start up st19xl it says Card Invalid 019, same problem with Cemu. Do I need a bew max mel flash 10c instead of 10b ??

I know I am forgetting something, can someone give me a clue.

Cheers
pecker88
12-17-2007, 01:36 AM
I have lost my manual, so I am lost. I just upgraded my 4900 to firmware 326 from 322, changed the firmware to No RSA Numbers, and wrote it back. Reread and it seems okay. Now when I start up st19xl it says Card Invalid 019, same problem with Cemu. Do I need a bew max mel flash 10c instead of 10b ??

I know I am forgetting something, can someone give me a clue.

Cheers

nag 019 usually means communication prob.
Boot up st19, then quickly go the sys info screen on ird. If it gives correct DNASP info Rom102Rev10B then your flash is ok.

This would mean that the problem lies elswere, likely a corrupted tsop.
Greystone
12-18-2007, 01:11 AM
That's how long it's been. DNASP is the card ID line ?? I boot and go to info screen but nothing there says rom102rev10b. I put back my working TSOP and still no go.

Thanks

nag 019 usually means communication prob.
Boot up st19, then quickly go the sys info screen on ird. If it gives correct DNASP info Rom102Rev10B then your flash is ok.

This would mean that the problem lies elswere, likely a corrupted tsop.
phreakydave
12-18-2007, 01:58 AM
That's how long it's been. DNASP is the card ID line ?? I boot and go to info screen but nothing there says rom102rev10b. I put back my working TSOP and still no go.

Thanks

I don't know a lot about your IRD but when I was getting the 019's it ended up being that I had not married the TSOP and card I was using correctly. Be sure you save both of them after applying the mods. If you've already checked that then I'm unsure what the problem might be. I also had to restart with a completely virgin TSOP and .cor to remove junk I ended up doing while trying to get it to work.
phreakydave
12-18-2007, 11:29 PM
OH, I might have had to update my setup to 10C, I know I did and I know that one of the 2313 flashes was bad so that could be your problem.