usb 256 problem

[pharcide]

Running xp pro hardware is detected but when I run software it say usb2.0 atmega not detected I have no problem with USB ports all working, is there anything else I can try, I tried other computers same problem. and yes i have 5 pin usb cable two of them. drivers were installed

[mili]

Did you install the USB Atmega256 drivers? You are not using a USB hub right? If no then it is possible the card is defective, I am sorry. If you bought it from me please read www.bellexpress.vu/rmf.html (http://www.bellexpress.vu/rmf.html)

mili

[JT]

Even though it may look like like the USB driver files that come with the software are the same as windows stock drivers, they are not. You MUST install the USB atmega256 drivers that come with the software specifically.

[pharcide]

Thanks mili for the quick response yes i had installed the drivers and now i tried to program on four desktops and 2 laptops no go. i can only assume the card is bad. and yes i did purchase from your site, again thank you for info.

[JT]

Mess with it some more, ask some more questions or what ever for a couple days, and if we can't get it worked out, mili has a really good and reliable return policy. If it's the card and you got it less than 30 days ago you will get a free replacement.

With that said, have you read the sticky posts in the USB atmega256 forum? It's very likely you have a mini USB cable that is not compatable. You must have a 5 pin USB cable, and believe it or not, there are huge differences between USB cables. Not all 5 pin cables are created equal either. I posted the exact cable you need in one of those stickies.

[pharcide]

device manger shows that USB ports are there enabled and working in device manager. i would love to play around with it for a few days if i could get some suggestions on some things to try im fresh out of ideas. and hair lol. i bought 5pin cable from site and went out and got another after seeing the sticky still no go.

[pharcide]

here is what it says Device type universal serial Bus conrollers Manufacturer FTDI location 0 (USB Atmega 256 Device Status This Device is working properly

[pharcide]

thanks for all the info and i am still working on it try different things with pc

[tariq211]

I JUST RECEIVE MY NEW USB ATMEGA 256 ,WHEN TRY TO PROGRAM ERROR SAY MFC71.DLL NOT FOUND,I INSTALL THE USB DRIVER USB2.0 Drivers.DOES ANYONE ELSE HAVING THIS PROBLEM.CAN THE LOADER OPEN WITHOUT THE CARD PLUG IN?

[joewilly]

Ran into same problem.Download from this site.http://www.card-coders.com/forum/downloads.php?do=file&id=777

[cojones]

dll has to be in same folder you open the 256 .exe from

[tariq211]

The Dll File Is In The Same Folder I Even Download The Mfc71 And Put It In The Same Folder.

[pharcide]

i feel your frustration i was never able to get mine figured out but i knew i was not the only one haveing this problem so i just keep reading hopeing someone will help with a solution..

[nugent]

Don't know if this is any help, but i had to down load the same (Mfc 71dll) to get mine to open. i just left it on my desk top!!!! and it worked for me!!!

[tariq211]

JUST SO EVERYONE KNOW I HAD TO PUT TWO DLL FILE IN THE SAME FOLDER ONE WAS msvcr71.dll AND THE OTHER MFC71.dll
THANKS FOR THE HELP :)
TOTAL 3 DLL FILE SHOULD BE IN THE SAME FOLDER
Atmega.dll THIS ONE COMES WITH IT.