Here are the public numbers you need to write to your IRD

[smilingjack]

Here are the public numbers you need to write to your IRD so that it works with the
USBAtmega256 Card.
Enigma Card
CEMU
ST19



Dish
IRD #: 01 1C 74 6C
Boxkeys: 8C A6 A8 8C FD E2 E2 63
CAM Number (hex) = 039A3174
.
.
ExpressVu Public IRDs

BEV #
BEV: IRD# R 00 4502 4458-77 - - -HEX (02AF04CA)
Boxkeys # FD BF 2E 56 AF FA 72 64
BEV CAM # [HEX] (1b2c3f1d )

[OU812]

I have been looking for a sticky or thread for putting public ird info on my 301-10. Can someone tell me where it is, or tell me how? HAPPY NEW YEAR!!!!!!!

[zhakrin]

To be honest the easiest way to do it is check here the file section here or the fileshop for the "NoRSA" version of your receiver flash (Model and build config), download it and put it on your receiver.

[OU812]

So-do I need to rewrite my ird to accept these numbers in order to get the usb to work? Why can't u just use DA and put you ird info in and write that to USB ATMEGA? Thanks!!

[smilingjack]

You either need to change you IRD to match the program
OR
you either need to change you programs to match the IRD
.
you IRD is 1 change
.
The programs, need to be change all the time.

[OU812]

SJ-Thanks!!and have a very very HAPPY NEW YEAR!!!!!!!!!!!!!!! Will have a shot of CR to you and yours tonite-SEE ALL L8TR--------------

[dragonslayer]

Do I space inbetween the boxkeys and ird but not the cam. I am having trouble getting mine going.

[smilingjack]

you put them as they are
just like the old ones

[bhmejia]

Hi

About the public numbers shown at the beggining of this post...

I used the public numbers in a DP301-013, one 4M Flash, aimming to the bird 110W, using the Atmega 256, Loader Ver 5.07.
I did the programming in the receiver, jtagging and VidMod, and programmed the ATMEGA256 too, the 4 areas, and I got these errors:

The Smartcard currently inserted is not valid for this receiver, ERROR 20,

Then pressing channel up and after of Acquiring satellite signal...

Your receiver has not yet been authorized, Attention 129, please call...
R0018642028-33
S0060436852-72

PST.
1. Before I backed up my flash from the receiver I let dish update it. Then I used flash Cloner 2.1, choosing Setup Source Dish Public, then copying the source (with publics), and vmod, erased and programmed back my receiver with this new bin.
2. I tried with the two set of keys 0101 and 0106, confirmed reading the keys back and didn't work, with Loader Ver. 5.07
3. I tried the whole procedure with other Atmega256 card and didn't work either.

Could anyone help me out?
Thanks in advance.