Please advice mikobu N2 Unlock Rom102 ver283

[egr551]

Hi all:
I just got dp311 with rom102 ver283. if anyone used yellow mikobu n2 unlock this ver283, please let me know what script used and what is ohm setting. Thank you
EGR

[skinerd]

Just about any rev 103 to 105 script will open a 283.

Just adjust it for a ----------------NoRsp---------+-----------+----+-------- type reading and give it a few mins.

[mtmt1us]

FTA Pirate 102 unlocker will get it. Turn pot slowly to right until you get bad cmd and program stops then turn it back to left just a hair then start it up again and it should pop. Good luck.

[ref]

FTA Pirate 102 unlocker will get it. Turn pot slowly to right until you get bad cmd and program stops then turn it back to left just a hair then start it up again and it should pop. Good luck.

ok will that work on a locked 102 rev 107 and do you turn pot while glitching?
and do you turn pot to your right with mik n2 in front of you as pot is on rt side hope this is not hijacking as i have same set up and only 1 card its married to a 301 thanks for any help......

[mtmt1us]

ref,
My above post was for a bga chip 102.
For a real card with mik n2 I would unhook mik with no card in it adjust pot until 1600 ohms is shown on a multimeter then use nagramaster to unlock. However I have not tried this with a rev 107.

[egr551]

Hi all:
I just run Rom 102 Rev 103-281-105-283 A0FF Intercept Script.xvb and set my loader at 200 ohm. I got error "Bad CMD04 response" Please tell what ohm shuold I set for mokibu N2 loader? thnak you
E

[mtmt1us]

Hi all:
I just run Rom 102 Rev 103-281-105-283 A0FF Intercept Script.xvb and set my loader at 200 ohm. I got error "Bad CMD04 response" Please tell what ohm shuold I set for mokibu N2 loader? thnak you
E

LOOK at the post above yours !!

Geez