no keys

[nomosno]

When I romcode I get unable to connect to remote server. So no keys. It seemed okay a couple days ago. Idon't know if the update messed it up. Anyone else get this problem? The last time I had this I had to reload software.

[James-x]

i just did a update its working great and i am not on a proxy server

[nomosno]

Thanks for the reply and info, guess I'll reload.

[nomosno]

I loaded new software from romcode site. Now I can conect to server, but when I open card it gets a ATR and the Rev but it gets a timeot error trying to get the provider. I can put cards on my old computer and it works fine. I am running Xp on both, but on the new one I am using a usb to srerial adapter. I have had trouble in the past with it so I got a new one it is better as I could not even get a ATR on the old one. Ihalfway thre but not quite. Any ideas?

[jacktha1]

try using diff drivers i used the ones in the files section and it worked for me

[nomosno]

Are these usb to serial drivers?

[jacktha1]

They are usb drivers, i have a usb to serial adapter and it worked for me

[nomosno]

Could't find it in files section.

[jacktha1]

go to the files section and use the search option, it was a challenge for me to find it at first to i just searched, but i think its under drivers

[nomosno]

I'll check in a bit. I hooked up my old computer so I could write my cards. got a 005 nag. I just came here to check the keys, they weren;t posted earlier.

[nomosno]

Found it under miscellaneous files & utilities. It was a rar. file but it was incomplete. Found one on driver detective Had auto install unlike the software that came with it. Although it appears to be the same driver. It is for a PL-2303. My old one was a HL-304. I even have tried PCI serial ports in the past. Most work for awhile then problems start?
It is really weird, every time I run it it stops at the same place (getting provider comm port error). I would think it would be a software problem. I just loaded fresh RC a couple days ago. Maybe I'll try again. Ideas?