Rom 102 Success Help ! !

[thatius]

I unlocked my ROM102 Rev 103 this morning with nagramaster ver.2
but when I try to read or write to it in the same program it say failed to write and the red light on my blue Nexus loader shuts off.

I really need to know exactly what steps to do after I get the card unlocked .
I am trying to load perkysaux-1.23 on my card.

[Wiley-X]

Can't remember if Nagramaster v2 was actually for loaders or not. I think you can glitch with a loader with that version, but not read/write with a loader.

I think you need an ISO programmer (different device altogether) to read/write with that software.

You might try downloading the latest Nagramaster (I'm pretty sure it has loader support).

Also, ocassionally NagraMaster says a card is unlocked (when in fact it is NOT).

So be aware of all of these when troubleshooting your situation.

~Wiley~

[helpless5]

I use Nagra Master Rom102 Loader Utility (older version)with Nexus Unlocker. It reads and writes to card no problems.

[thatius]

I am using Nagra Master Rom102 Loader Utility and when i try to write or read i still get (failed to write eeprom )
Do i need change my nexus 2,5 down or take my card out and stick in my iso to read and write.
and should i write a clean image on imediately or what do you guys suggest THANKS.

Submit this failed Write report for support:
Write Failed at Addr: 3080
$3170 = 4003880030100005050060DB9A400095
$3180 = 998005008859807500812B80A0008AB3
$3190 = 80C80000000000000000000000000000
$30C0 = A7BF8703808000000000000000000000
$8219 = 00000000000000000000000000000000

[helpless5]

Try this post it should get you going.
hxxp://www.dssftp.com/forum/showthread.php?t=63182

[aposton]

I am using Nagra Master Rom102 Loader Utility and when i try to write or read i still get (failed to write eeprom )
Do i need change my nexus 2,5 down or take my card out and stick in my iso to read and write.
and should i write a clean image on imediately or what do you guys suggest THANKS.

Submit this failed Write report for support:
Write Failed at Addr: 3080
$3170 = 4003880030100005050060DB9A400095
$3180 = 998005008859807500812B80A0008AB3
$3190 = 80C80000000000000000000000000000
$30C0 = A7BF8703808000000000000000000000
$8219 = 00000000000000000000000000000000

I don't want to step on any toes or anything,different people use different methods,I always use ISO to write to and clean my cards and loader for glitching.maybe its just what I am used to,but it works everytime. Yes write a clean rev103 image to card immediately after opening.

[old school]

I would guess that the card is not really unlocked. I too, have had scripts say card is unlocked when it really wasn't. The red light comes on to signal that it is unlocked, but it's really a false read. Of course when you go to read it the red light goes out. Just me guessing tho'.