301-010 & gendt08

[ricollie]

I have a 301010 that will only work the the original flash. If I use gendt08 on it, it will no longer work. The light will come on and then go right off. I have used every guide I can find and I still end up with the same results. Even if I put a downloaded flash onto it, it still does the same thing. Does anyone have any idea of what I am doing wrong?

[Dirkk]

I have a 301010 that will only work the the original flash. If I use gendt08 on it, it will no longer work. The light will come on and then go right off. I have used every guide I can find and I still end up with the same results. Even if I put a downloaded flash onto it, it still does the same thing. Does anyone have any idea of what I am doing wrong?
Read this and follow exactly.http://www.dssftp.com/forum/showpost.php?p=459740&postcount=2:)

Dirkk

[ricollie]

I have followed that guide plus several others. I still get the same results. if I modify the flash at all it will not work. the green light comes on and the goes right off. I put the original file back on the ird and it boots up fine. I then tried a downloaded file from the net. The light comes on then goes right off. I have never had this problem before.

[Dirkk]

I have followed that guide plus several others. I still get the same results. if I modify the flash at all it will not work. the green light comes on and the goes right off. I put the original file back on the ird and it boots up fine. I then tried a downloaded file from the net. The light comes on then goes right off. I have never had this problem before.

you know ? you have to leave it in the stream for awhile once you hook it back up. It's normal for the light to be out and it will blink on intermittently till it updates. may take an hour or so. hang in there
Dirkk

[ricollie]

I forced it to take the latest update before I started. (P392) I followed the guide, left it in the stream overnight, I still get the same results. Its strange I know.

[mannybeef]

first the light does come oon and then goes off but should come back on again.
try manually powering on. ( like you havent .lol)

you can obviously flash tsops and such or you wouldnt know that the original when written back to 301 do work

so its complications from gendt08

there are many guides for gendt08 find one with pictures.
not kidding, its better to grasp the most important steps
leave nothing red, crc

and use flashedit load the tsops after creating in gendt08 and if they load in beginner mode there good if not there bad
if good in flashedit use save virgin eeprom script and save being sure to enter the correct bld cfg from inside box sticker and not the tsop bld cfg in capitals

[ricollie]

thany you guys for all your help. I will try it in the morning and let you know the results.

[richard smith]

Hi ricollie, I did the same work like u before. But my receiver is book up fine. The problem what i got is no picture. Got "your smart not autho ..................." nap over night.then i read the card, fund the keys been autorolled correctlly. no idea whats wrong!!!!!!