retnuh
01-13-2008, 08:00 PM
Up until about six months ago, I was using three 301.013 units. Then all of these 301s started acting like a key update was needed. The guide would be up-to-date and they would display the free channels like 101, 500, NASA, etc.; however, all other channels would only display the channel info at the top of the screen. The picture would be a blank screen. I could pull the Atmega128 cards and place them in my 2700 and 3900 units and they would work fine. This was true with Phoenix or Satjammin.
Yesterday, I downloaded the latest Phoenix program and installed it on my Atmega128s. I am experiencing the same results. The 2700s and 3900s all work. The 301s do not.
Equipment:
301.013 single chip with NoRSA and public numbers
Software version X346
Atmega128 18.0 chip
Things I have tried:
Switch test (Receiving good strength on both satellites)
Hard reboot of receivers (Left unplugged for weeks)
Removing and re-inserting card
Any help will be much appreciated.
retnuh
Yesterday, I downloaded the latest Phoenix program and installed it on my Atmega128s. I am experiencing the same results. The 2700s and 3900s all work. The 301s do not.
Equipment:
301.013 single chip with NoRSA and public numbers
Software version X346
Atmega128 18.0 chip
Things I have tried:
Switch test (Receiving good strength on both satellites)
Hard reboot of receivers (Left unplugged for weeks)
Removing and re-inserting card
Any help will be much appreciated.
retnuh