Atmega 128 Freezing fix

[asajwani]

I am using latest Phoenix Atmega loader 1.2 and I am getting freezing every 1-2 hours in receiver 2800. Just take the card out and put it back.

Just wondering If there is any solution for it or it is normal with other people.
Please post your rest with the receiver so everyone knows it.

[AOAOAO]

Yes this is normal for everyone at this time.
Solution: You can allways subscribe.

[gallo55]

Yes this is normal for everyone at this time.
Solution: You can allways subscribe.

ROFL ROFL ROFL ROFL

Good one, Another stupid question answered you can close this thread lol lol

[satsatsat]

I think ur comment is just stupid comment. This is just a question that someone is asking. I am sure you were stuck and needed to ask a question before.

[AOAOAO]

Asajwani
Pheonix 1.2.3 is out and the freezing is fixed, you won't have to sub lol

[SATTROY3M]

Any new Jeeper file for the freezing ? i dont use Pheonix.. Thanks

[cmdr-franck]

I think ur comment is just stupid comment. This is just a question that someone is asking. I am sure you were stuck and needed to ask a question before.

Come on .. with all that as been playing out lately .. some little laughter is not so bad.

I fool around all day like that .. even to my boss ... just relax and instead of seeing thta as an attack .. so laugh a little.

[taf]

running new jeepers file. called roms atmega 128. running for over 6hrs and not a single freeze, wide open. phoenix has been hell for me, cant get past smartcard error. just load new roms pfg into jeepers clean/erase chipset as normal No need to add anything else. and full monty. i didnt even change xtal speed running 18mhz board left jeepers on 18.432 took all of 10 mins to do card. wait for roll. try it its better than phoenix.. do disrespect to team phoenix. they and all coders work so hard . and deserve a big thanks..... taf :D

[cmdr-franck]

running new jeepers file. called roms atmega 128. running for over 6hrs and not a single freeze, wide open. phoenix has been hell for me, cant get past smartcard error. just load new roms pfg into jeepers clean/erase chipset as normal No need to add anything else. and full monty. i didnt even change xtal speed running 18mhz board left jeepers on 18.432 took all of 10 mins to do card. wait for roll. try it its better than phoenix.. do disrespect to team phoenix. they and all coders work so hard . and deserve a big thanks..... taf :D

Well this llok slike things of the past .. BEV as just activated new ECM .. so we're back down the drain.

[taf]

still running like a swiss clock here. however i am running 2 3100 on DISH.? so i cant comment on bell? taf