Can POWERSYNC Unlocker also program rom 103?

[arminzol]

I just purchased Powersync unlocker with MAX4619 and 74HC4053 Chips to unlock my rom 103 rev308, can I also use the Powersync to program my cam? or am I better off to purchase the Nexus ISO Programmer?

[DonaldTheGiver]

in my very personal opinion, i would get a seperate iso for programming, there is some softwares that will allow you to used a loader to program cards as well as unlock them, but once again in my opinion those softwares are no good, so if i was you i would just get a iso programmer, not trying to take away from mili here but if you look around you can usually pick up a cheap iso programmer from anywhere from 10-20 bucks, depends where you look, im not gona say though, or you can order from here, mili is a well known trusted person.

[retiredguy]

i have to differ from donaldthegiver. I have programmed all of my cards for at least 2 years with my powersync without issue. I gave my iso to a family member to use after I got my powersync and have used it since. i did not own an iso until recently I had to purchase a few to do ST19.

[Bacab]

U can use RM1A for all you card programming with an unlocker. That's what the program was designed to do.