PDA

View Full Version : majic card


budme
01-28-2008, 10:29 PM
is it posible to turn a mc into a amega 128 or any of the outher cards on the market or is there just not enough memory on it

ellsmako
01-29-2008, 12:12 AM
I did manage to turn my magic into a 102 BUT you will need a 102 chip from a 4100 with low rev. Its a bit of a night mare to wire but it does work, Basically though anything with pad will work so I used a couple of my magics as donor board, the trick is unlocking the 102 from the 4100 without looping it, Blue nexus less than 9 volt with omni unlocker etc. I did get good use out of the magic however short it was,...lesson learned

sensation
01-29-2008, 02:27 AM
Can the magic card be used on Blocker mode for Rom 10X?

Thanks

ellsmako
01-29-2008, 03:18 AM
The card ( chip ) itself is useless , I only used the body of the card for a 102 chip mount simular to a bga . I was explaining the only use I had for it besides a thin cheese cutter

smilingjack
01-29-2008, 03:19 AM
Can you post the schematic on that
I got a several..........
Thank, Jack


I did manage to turn my magic into a 102 BUT you will need a 102 chip from a 4100 with low rev. Its a bit of a night mare to wire but it does work, Basically though anything with pad will work so I used a couple of my magics as donor board, the trick is unlocking the 102 from the 4100 without looping it, Blue nexus less than 9 volt with omni unlocker etc. I did get good use out of the magic however short it was,...lesson learned

ellsmako
01-29-2008, 03:23 AM
Looking for it now

ellsmako
01-29-2008, 03:30 AM
Sorry about that budme, I seem to have hijacked the post,

no way to turn a magic into a 128, but as a donor bga card it will work

ellsmako
01-29-2008, 03:47 AM
These have worked for over a year, tinee tiny soldering not for the beginner.

itsbeenawhile
01-29-2008, 06:33 PM
that is a pretty good solder job, i definately do not have the skill to pull that one off

mruk69
01-29-2008, 10:18 PM
itsbeenawhile,

Maybe if you pay the Magician the support fees again, he will do it for you.:D

ellsmako
01-29-2008, 11:51 PM
I did the solder job a a challenge,. actually smacked my head under the desk when it opened ( homer simpson voice,.... I am so smart SMRT I mean smart ,..), they were pretty star and very colorfull. two of my friend and my wife were kinda impressed, I was more surprised.

OH yeah it help to use a video micro scope from work.