5900 tsop write

[adika]

when jkeys detects my board , the IRD# and Boxkeys are all zeros. I haven't been able to successfully write to either TSOP chip again.(was able to delete once and rewrite)
With the vid mod turned on, I get the "DQ5" error.
With vid mod off, jkeys writes 99% before stopping at offset 7FBFE000 (Flash 1) or at 7FFFE000 (Flash 2).
Any suggestions?
thanks

[day_tona2]

with vid mod on if get dq error try going in to the programind mode reboot recever detect just keep playing with it i had 1 do that befor you just got to mess around with it tell it goes you will always get to 99 with it off but it wont write the locked sector so if all your wires are ok keep playing with it

[skinerd]

Go to receivers forum and read, a ton of info is posted on these, they are physically same as a 510.

Words to know........vid mod, OJ1, learn what hey are and how to use them.

Then when you get stuck, ask, we will help.