ST19xl command line options

[drwho]

What command line options should use use with st19xl and aux card? I am only using -m (for maxmel) and -paX and -peX to point to com ports.

Will ST19xl take updates to the cor, including key rolls (including the 901, 905 and 906 provider keys for b&v)?? Are any extra command line options needed to do this?

[bud02]

I use these
ST19XL.EXE -a -m -s -pe1 -pa4
-a enables aux

[jughead69]

-o in your command line will cause the cor not to be saved on quitting the program using shift Q. Without the -o command st19 will save current cor on exiting program.

shift c will save cor while st is running.

[jughead69]

As for updates, I haven't been able to get a cor to update revs, I've had to patch the rev updates to my private cor.

Once the cor is at the proper rev, with the new provider keys patched in, the cor should update keys and do writes to the cor that you can then save.

As far as I know there are no settings to worry about for cor writes, it does them in order to keep the cor working.

[ruciz]

St19 works fine for updating COR revisions.
When 248 and 10C came into play my COR files both updated perfectly to the respective revisions. If they don't update theres an issue with your COR file. If you are starting out with a clean Rev like 240/103 and expect it to update to latest rev you will be a while - likely 3-5 days before all the updates are in place.. It will work tho, just takes forever. quicker to write patch to bin.

all you need for commands is aux, maxmel, and your IRD and AUX com ports. I also turn on writes..

st19xl -a -m -w -pe1 -pa2