atmega128 and 510

[adika]

i load satjammin file, i have audio on some channels but no video...im running first time on 510 public nr.
any ideea what could be wrong?
thanks

[wtp]

did you remove sk's? to run public on a 510 you need to run dt08. use workmens flashedit and you can remove the sk's with that. I had the same trouble this last weekend.

[adika]

i removed it wih flashhedit...opened original tsop in moved ird info and applyed remove SK with dish public nr. after opened again in moved ird info and edited the new numbers and fixed crc and saved new bin...is not this the right procedure cause i have a 510?
thanks

[wtp]

if i remember right what i did was took the original flash and opened it in workmens flashedit. choose remove sk's and apply. save tsop. open new saved tsop and fixed crc and saved flash and made virgin eeprom. I didn't have to edit anything. when I removed sk's workmens flashedit put in the public info. here is a link. like i just said. i had the same problem.


http://www.dssftp.com/forum/showthread.php?t=76719

[adika]

if i remember right what i did was took the original flash and opened it in workmens flashedit. choose remove sk's and apply. save tsop. open new saved tsop and fixed crc and saved flash and made virgin eeprom. I didn't have to edit anything. when I removed sk's workmens flashedit put in the public info. here is a link. like i just said. i had the same problem.


http://www.dssftp.com/forum/showthread.php?t=76719
i have the kit for 510(workmen) but theres one thing that confuses me
if u open the tsop as a moved bootstrap info after i'm done flashing when reading with jkeys at 501/5100 it gives u the right info but when u select 510/5900 it gives me R00...1-96 and FFF at box keys is that the right way??
what i did is i saved tsop in moved ird info anyway ill try the other way
thanks