Dp 301-013 Single Tsop

[dpateld]

I got a major problem allow me to describe the problem
i did the vidmod on this dp 301-013 single tsop which is comes out to be 4194304 bytes = 4 MB ok i also grounded the r-79 to the first pad on jtag from the top side. i have the right jkeys to do this on 301-013 i can read the tsop and also i saved it so i can edit it in flashedit, cause i am also a romcode member. now after i edited the ird and boxkey in flashedit with the new ird and boxkeys i tried writing it back into the 301-013 the jkeys will write all the way through except the very last % means it will write 99% of the flash and then it comes back and gives me an error that says " ERROR PROGRAMMING FLASH AT OFFSET 0x7fffffac " can anyone of you smart guys PLEASE tell me what is it that i am doing wrong and how do i write the whole flash without a problem i folled the guide on how to do a vid mod from the bevexp. site from here. got so many 301-013 sitting around just collecting dust please help. if there is any other way to do a simple vidmod i will try that out also please help thank you very much
sandman

[Bandit5906]

If you were programming with the vid mod in the on position then it is not wired correctly. Check your connections.

The vid mod has to be on to program your TSOP.

[skinerd]

The vid mod must put approximately 12v on SB35 for it to enable erese/write of the last sector of the flash. Actually anywhere from 8.5 to 13.5 should be ok for the volts on SB35.