rom102 unknown provider card

[ge2]

I got a rom102 card rev 103 that I can read and write to it, but I get unknown provider. I wrote clean image to it and it says dish provider, but when I write original image it says "unknown". Data pointer at $30C0 is OK. ($30C0=A7BF8703808000000000000000000000)

Is there anything else in the bin I have to fix for ptoper provider? Thanks.

[bud02]

Sticky @ top of page you started this thread in
http://www.dssftp.com/forum/showthread.php?t=63571
Thats the data pointer, other than that are you sure your looking at the updated image?

[bud02]

I had a problem while back writing AIO to card always came back no provider.
changed the read write in N2edit, command to 100 and read byte 100
fixed it

[Chicoboom]

I had a problem while back writing AIO to card always came back no provider.
changed the read write in N2edit, command to 100 and read byte 100
fixed it

hi Bud... Could you please explain yourself... How can I change that comand 100???

I can read my 102 card in Nagraedit but not write... In Nagra2edit not reading not writing!!! just Unknow provider

This is what I get in Nagraedit 2.58:
Opening COM1.
ATR String: 3F FF 95 00 FF 91 81 71 FF 47 00 44 4E 41 53 50
31 30 32 20 52 65 76 31 30 30 64
ROM ID: DNASP102 (ROM102)
REV ID: Rev103
IFS has been set.
Backdoor found.
Backdoor ready for communications.
Writing temporary interceptor.
Writing EEPROM...
Restoring DataSpace Pointer.
Failed to prep updating of BugCatcher table.
Updating BugCatcher table.
Failed to updated BugCatcher table.
Failure writing card.
Closing COM1.

[bud02]

hi Bud... Could you please explain yourself... How can I change that comand 100???

I can read my 102 card in Nagraedit but not write... In Nagra2edit not reading not writing!!! just Unknown provider

Command and byte delay are settings in N2edit not nagraedit.
by changing them from the default to 100 sometimes prevents bad writes.
Try reading and writing in N2edit2.58
Nagraedit52 relocates the intercept to a different location on card. Or you have something partially written to it.

If your card is no provider take an image from the card and edit the $30C0 line and write it back to card. The link above tells you how to do that for different cams and providers.

[satexplorer]

I got a rom102 card rev 103 that I can read and write to it, but I get unknown provider. I wrote clean image to it and it says dish provider, but when I write original image it says "unknown". Data pointer at $30C0 is OK. ($30C0=A7BF8703808000000000000000000000)

Is there anything else in the bin I have to fix for ptoper provider? Thanks.




put a virgin image on it,then get a new bin .dont put the same one.