Random Freezing...

[dssexpert]

I switched a lot of things in the past week, so before I start back-tracking I want to make sure I am the only one experiencing this...

I had 2 st19xl running cardless through auxshare.
I added a USB to Serial adapter, which is attached to a PK1.23 aux card.
I switched to superforge (running on the same computer) and 2 superforge clients for the 2 instances of St19xl.

Everything seems to run OK, but I am getting random freezing every few minutes that usually lasts around 30 seconds.

I am also seeing some ! on the st19xl window

I closed everything out superforge and am now running st19xl straight with the aux.

st19xl.exe /m /o /a /pa9 /pe2 st19.cor (where my aux is through the USB to Serial adapter on port 9, and my maxmel is on port 2) and I am still getting freezing. I'm thinking its either the usb to serial adapter, or it is happening to everyone?

Any suggestions? I thought these usb to serial adapters either worked or didnt work....?

[sLaShEr]

There are other reports that people are experiencing freezing when using the latest version of ST19 with an aux card.

If you are testing d*sh - try going back to Auxshare (latest version) as d*sh is currently using map22. See if your freezing now goes away.

If you are testing b*v - then Auxshare won't work because I think they are still using map57 with timing - which means you will need a real smartcard.

sLaShEr.

[dssexpert]

Tried with Auxshare and just got unknown map packet errors and completely black screen.

went back to aux card and getting freezing. guess its just a wait for a new st19xl

[JT]

Cemu 2.05 is working for dish right now. Check out SJ's sticky post.

[Greener73]

Running fine here with aux, newest st19 and 301 with private numbers

[harrybuckman]

The newest .27 works fine in dos with 3.57 and 3.68 but in windows it freezes on some channels.