322 resetting

[tamng78]

I finally got my 322 going everything seem to be working fine, activated cardslot everyting is showing in system info card is detected. The problem is the receiver is keep resetting itself every 10-20 seconds. It blink saying that receiver communication error real quick and reset. any helps would be greatly appreciated Thanks

[skinerd]

Communication error means that it dont see the card chip or it is programmed bad. Double check the mod, some methods call for trace cuts, make sure those done right.

[dolomyte]

i got someone else who has the same problem, st19 seems to stall with there 322. they said something that made me think there reciever had recently takin
an update aswell. Can anyone confirm if 322's have had a recent update or not?

[havok]

I was having the same problem with st19xl and my 322. My receiver kept rebooting with the same message. I then tried countless 38b flashes on my max/mel until i found one that worked. If you are using the I-Cam that you removed you shouldn't have that error. If you do check all of your connections.

[tamng78]

I have double checked and went over it all connection seem fine. I dont think it connection problem as i can access to menu and system info show my cam id. Ird dont stay on look enough to do anything its reboot every 10 seconds. My software is at 248 could that be it?

[wjwatt123]

I had the same type of problem with a 311 a while back, which I hadn't used before. I had to disconnect the sat cable and do a check switch, then hook the sat cable back up and check switch again.