Any st19xl B3V working without aux?

[lattman]

Hey guys, what about B3V? any st19xl fix wihout aux?

Thx

[Grasshopper2Ant]

Try 26.28 with a B3V .COR.

Working for me!

[lattman]

Which aux share are you using? I'm gettinf smartcard not inserted error?

[ruciz]

you have further problems than ST19 if you get error 19.

[t160hq]

Which aux share are you using? I'm gettinf smartcard not inserted error?

No auxshare program needed.

Just the st19 program with the -a command removed from the autoexec.bat file.

Currently no map calls are being used. So no aux card or auxshare program are needed.

Likely won't last long so enjoy it while it does.


t160hq

[lattman]

I'm on windows, so I guess the -a command doesn't apply? I haven't change anything to my settings, all was working fine until a couple of weeks back..

Note: Is there 2 versions ov .28 out there? one for B3V and one for Dish?

[t160hq]

It does apply. Even running in windows you still have to run st19xl.exe with the
proper paramaters for your setup. That means using a autoexec.bat file to start
it or typing the entire command line with parameters every time you start it.

Just double clicking on the st19xl.exe won't work.

It works cardless on b3v. You still need to set up your autoexec.bat
in the windows folder to run cardless. Especially if you were
running some form of auxshare before.

eg: create or modify a autoexec.bat file in the windows folder containing the windows version of st19xl.exe.
Also make sure you have the files st19.cor and st19.rom in the same folder.
Create or modify the autoexec.bat with the line:

st19xl.exe /m /s /t /w st19.cor

leaving out the /a command for a aux card or any commands refering to the auxshare
program. changing the st19.cor to whatever your .cor file is named if different.

Only one .28 version that works on both.

t160hq

[lattman]

There is a batch file in my st19xl folder called st19.bat with the following command, START "ST19XL" ST19XL.EXE -a -m -pa3 ...I guess this should be fine, version 27 works fine but freezes quite a bit while 28 doesn't work @ all..

[bono975]

version 21 works perfectly...on B*v

[pp22]

version .28 working perfectly on bev for me

[lattman]

After adding st19xl.exe /m /s /t /w st19.cor to st19xl.bat , all is working well!!!

Thx t160hq..

It does apply. Even running in windows you still have to run st19xl.exe with the
proper paramaters for your setup. That means using a autoexec.bat file to start
it or typing the entire command line with parameters every time you start it.

Just double clicking on the st19xl.exe won't work.

It works cardless on b3v. You still need to set up your autoexec.bat
in the windows folder to run cardless. Especially if you were
running some form of auxshare before.

eg: create or modify a autoexec.bat file in the windows folder containing the windows version of st19xl.exe.
Also make sure you have the files st19.cor and st19.rom in the same folder.
Create or modify the autoexec.bat with the line:

st19xl.exe /m /s /t /w st19.cor

leaving out the /a command for a aux card or any commands refering to the auxshare
program. changing the st19.cor to whatever your .cor file is named if different.

Only one .28 version that works on both.

t160hq