ROM 102 Bad Write

[MPeter3628]

OK, I have a Rom 102 that I screwed up the writing to by using N2edit for part of the programming, and Nagraedit for the other part. I have tried many scripts and programs and still no luck. I am now going to track which ones I have used, and the results from them. If anyone has any ideas please let me know. I will add to this thread as I try more scripts.

OK, so I have a Rom 102 that is spoofed to 10C.

Using N2edit w/ ISO programmer, I get an ATR, Rom 102, Rev 10C, provider unknown, failed to read card. Also, cannot unlock card with password.

Using Nagraedit w/ ISO programmer, I get an ATR, Rom 102, Rev 10C, IFS has been set, could not test for backdoor, failure reading card. Also, cannot unlock card with password.

Using Nagramaster w/ white nexus flashed w/ ND13, 2 and 5 down, I get card locked. When I try to unlock I get Rom 1, Rev 1, unable to unlock.

Using RM_1A w/ white nexus flashed w/ RSX1, 2 and 5 down, trying to unlock I get "improper cmd22 response" unable to continue.

Testing other scripts........................................... ...

[Sikorsky]

Yeah that sounds like you need to re-glitch as you are attempting to do. The card is boogered up from switching utility program intercepts. If your original rev was a 105 or a 103 try re-glitching with the RebelSerf 102 OmniUnlocker.xvb script. It's always worked good for me. :)

[MPeter3628]

I tried rebelserf's omniunlocker stubborn fix flashed w/ ND13, it ran for 5 hours without unlocking.

Also tried rebelserf's provider unknown fix, it just kept running, no luck.

[Fro66er]

It should not take that long if your pot is adjusted properly. Tweek at that pot some more till you get the proper responces. Just moving it a cunt hair can make all the difference between hours or minutes unlocking. When I say cunt hair, I mean such a small adjustment, you don't even feel the pot moving - only verified with a DVM.

After a small hardware modification to my unlocker, it now takes me less than 1 minute to unlock most cards. It uses a different vcc to cam's glitch, and uses a 10 turn pot. With this 10 turn pot, even the slightest turn, huge diffferences are seen. If I get a chance, I can try to upload it to the file section.